Manual Installation from Netware Client Diskettes
Note: The remaining instructions in this section assume your boot drive is drive
C:.
2. Copy the NWUNPACK.EXE utility from Disk 1 (or the diskette you created from
the VLMKT1 archive file) to a place where you can invoke it easily for the
following steps, as in the following example:
C> COPY A:\NWUNPACK.EXE C:\NWCLIENT
C> NWUNPACK A:\LSL.CO_ C:\NWCLIENT
C> NWUNPACK A:\IPXODI.CO_ C:\NWCLIENT
To use a driver from the client disk just mentioned, decompress the driver's
executable file (a .CO_ or .EX_ file) to the C:\NWCLIENT directory:
C> NWUNPACK A:\DOS\NE2000.CO_ C:\NWCLIENT
If you obtained your driver elsewhere, make sure it is copied to the
C:\NWCLIENT directory.
If you are using the purchased set of diskettes from Novell, copy the file
TCPIP.EXE from the TCP/IP Transport for DOS disk to the
C> COPY A:\NET\BIN\TCPIP.EXE C:\NWCLIENT
C> COPY A:\NET\BIN\PING.EXE C:\NWCLIENT
C> COPY A:\NET\BIN\PING.MSG C:\NWCLIENT
C> COPY A:\TCPIP.EXE C:\NWCLIENT
C> COPY A:\PING.EXE C:\NWCLIENT
C> COPY A:\PING.MSG C:\NWCLIENT