Using Novell's 16-bit NetWare Client for DOS/Windows

The NetWare Client for DOS/Windows has a simple, easy-to-use installation program that will copy all the files you need onto your hard disk and configure your DOS system files to load the network software when you boot. However, the NetWare Client installation program copies more files than are needed to support an AspeNet Server. Consequently, you will need to manually edit two configuration files to remove references to unnecessary software modules and modify a few parameters.

If you are experienced at using DOS and configuring network software, follow the instructions in Manual Installation from NetWare Client Diskettes

to install and configure the minimum set of required modules. Otherwise, proceed to the next section.

Using the Netware Client installation program

Manual installation from Netware Client diskettes